Bose Personalized Amplification System Operations Instructions download pdf (Page 21)

Operating Instructions

Svenska Nederlands Italiano Français Español Deutsch Dansk EnglishDanskDeutschItalianoNederlandsSvenska Français Español English

Using parallel effects connection with the PS1 power stand

Note: Connecting an effects unit in parallel requires one ¼-inch unbalanced (instrument) cable,

one mono ¼-inch phone (M) to dual mono ¼-inch phone (F) “Y” cable adaptor, and one TRS split

“insert” cable (with a ¼-inch TRS connector on one side and two mono ¼-inch phone connec-

tors on the other).

1. Insert the TRS plug into the Channel 1 Insert jack on the PS1 power stand.

2. Connect both ¼-inch plugs from the “insert” cable into both receptacles on the “Y” cable

adaptor.

3. Connect the plug of the “Y” cable adapter into the input of the effects processor.

4. Connect the ¼-inch unbalanced (instrument) cable from the output of the effects 

processor to Channel 3 Line IN of the PS1 power stand.

5. Set the effects level of the processor to full and turn the mix level of the effects processor

to full “wet”.

6. Adjust the Channel 3 Level control of the PS1 power stand for the desirable effects mix.

Figure 9

Using a parallel effects

connection

TRS split “insert” cable

1/4-inch Instrument Cable

Mono 1/4-inch Phone (M) to

dual mono 1/4-inch Phone (F)

“Y” cable adaptor

Connect to Effect Unit INPUT

Digital Effects Unit

Connect to Effects

Unit OUTPUT

Connect to

Channel 3 Line IN

Connect to

Channel 1 Insert

PS1 power stand

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 27 28

No comments

Bose Personalized Amplification System Operations Instructions Page 21