Bose Personalized Amplification System Operations Instructions download pdf (Page 13)

Setup

Svenska Nederlands Italiano Français Español Deutsch Dansk EnglishDanskDeutschItalianoNederlandsSvenska Français Español English

Connecting two B1 bass modules

Connect the first B1 bass module to the PS1 power stand as shown in “Connecting one B1

bass module.”

Insert one end of the second B1 bass module cable into the unused jack on the rear panel of

the first B1 bass module. Insert the other end of the cable into one of the jacks on the rear

panel of the second B1 bass module.

CAUTION:

Do not connect more than two B1 bass modules to the B1 Bass Module (Amp 3

OUT) jack on the PS1 power stand. Driving more than two B1 bass modules from the B1 Bass

Module (Amp 3 OUT) output will improperly load the amplifier in the PS1 power stand resulting

in poor system performance.

Note:

Use only the supplied (blue) B1 bass module 4-wire cable to connect B1 bass modules

to the PS1 power stand. The PS1 power stand uses the signals on two of the four wires to

automatically sense how many B1 bass modules are connected to it. DO NOT SUBSTITUTE

the supplied cable with a 2-wire speaker cable.

Figure 7

Installation of two B1 bass

modules

B1 Bass Module

(Amp 3 OUT)

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 27 28

No comments

Bose Personalized Amplification System Operations Instructions Page 13