Bose T1 User Manual download pdf (Page 57)

CARE & MAINTENANCE

SvenskaItalianoFrançaisEspañolDeutschDanskEnglish Nederlands

Problem What to do

T1 is plugged in, power

switch is on, but no power.

• Make sure you have power at the AC outlet. Try operating a lamp or other equipment from the same AC outlet or

test the outlet using an AC outlet tester.

If using the T1 with an L1

model II system:

• Make sure the ToneMatch

cable is properly connected to the audio engine and the L1 power stand.

• Verify that the power cord plug is fully inserted into the power stand and the AC (mains) outlet.

• Make sure the L1 power stand is turned on and the power LED is blue.

If using the T1 with an L1 model I system:

• Make sure the audio engine is properly connected to the T1 audio engine power supply.

• Verify that the plug of the T1 audio engine power supply power cord is fully inserted into the AC outlet.

• If available, try a different T1 audio engine power supply.

T1 is on, but there is no

sound.

• Make sure the Master volume control is turned up.

• Verify that the input channel(s) you want to hear is not muted.

• Check that the Volume control is turned up for the channel you want to hear.

• Make sure the appropriate input channel Trim control has been turned up enough so that the green LED is on

(indicating that there is a strong input signal).

• Check the Prefs (Preference) Input and Output level meters to confirm that there is a signal at both the input and

output stages.

• Make sure volume control is turned up on your input source (instrument).

• Connect your input source (instrument) to the audio engine using a different cable.

• Plug your input source (instrument) directly into the L1

power stand or a different amplifier to make sure the

source is working.

• Turn the audio engine off and wait 30 seconds. Then turn unit on again.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62

No comments

Bose T1 User Manual Page 57