Bose T1 User Manual download pdf (Page 24)

EnglishDeutschEspañolFrançaisItalianoNederlandsSvenska Dansk

OPERATING INSTRUCTIONS

IMPORTANT!

Optimizing input gain and output volume

Getting a quality volume level from your system relies on the combined adjustments of input channel gain, master

volume, and channel volume. Do the following for each channel used.

1. Make sure the Master volume, Trim, and channel volume controls are set to 0.

2. Adjust input channel Trim.

A. If applicable, adjust the volume of your instrument/source to the desired level.

B. Play your instrument/source at a performance level.

C. Slowly turn the Trim control clockwise until the signal/clip indicator glows green or just starts to flash

yellow. If the indicator flashes red or glows steady red, turn the Trim control counter-clockwise to

decrease the level.

D. Use the input level meters (page 29) in the Prefs menu to check your input levels.

Note: If you are using a device that requires phantom power (+48V), such as a condenser microphone, depress

the Phantom power switch before adjusting the Tri m control.

Note: The input level meter in the Prefs menu can be helpful when adjusting the input Trim level (see page 29).

3. Set the Master volume control at the 12 o’clock position.

4. Slowly turn the channel volume control clockwise until the volume reaches the desired level.

Input Level Preferences

CH1 . . . . . . . . . . . . .

CH2 . . . . . . . . . . . . .

CH3 . . . . . . . . . . . . .

CH 4/5 . . . . . . . . . . . . .

Menu Reset

Peak level

indicator

Input level

indicator

(Example)

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 61 62

No comments

Bose T1 User Manual Page 24