Bose T1 User Manual download pdf (Page 58)

CARE & MAINTENANCE

EnglishDeutschEspañolFrançaisItalianoNederlandsSvenska Dansk

T1 is on, but there is no

sound – Continued.

If using the T1 with an L1 model II system:

• Turn off the power stand, re-seat the ToneMatch

cable plug in the ToneMatch port, and turn on the power

stand again.

• If available, try a different ToneMatch cable. If another ToneMatch cable is not available, try a standard ethernet

cable.

• Connect the T1 Master output to the Analog Input on the power stand using a ¼" phone plug cable. Turn up the

power stand Trim control, and verify that you hear sound.

• Make sure power LED on power stand is blue. If LED is red, please call Bose Live Music Customer Support at

(877) 335-2673 for assistance.

If using the T1 with an L1 model I system:

• Make sure the T1 Master output is connected to the Channel 3 or 4 Line IN on the power stand. Turn up the

power stand Channel 3/4 line input Level and verify that the system is producing sound.

• If using the R1 remote control with the system, make sure the R1 Master volume is turned up.

• Make sure power LED on power stand is green. If LED is red, please call Bose Live Music Customer Support at

(877) 335-2673 for assistance.

Poor quality sound from a

microphone or instrument

connected to the T1.

• Make sure there is no unwanted zEQ or Para EQ equalization applied.

• Verify that you have selected an appropriate ToneMatch

engine preset for your microphone/instrument. If you

do not want to use a ToneMatch engine preset, make sure ToneMatch is set to Flat.

• Make sure there are no unwanted effects (Comp/Gate, Mod, Delay, Reverb) on your input channel. Check the

Status in the Prefs menu for any currently active effects.

• Check that the T1 input Trim is adjusted properly for your microphone/instrument. The signal LED should be

green; if the LED is red, lower the Trim level until it is green.

• Try a different microphone or instrument cable.

• Check the cable connecting your microphone or instrument to the T1 audio engine. Make sure the cable plug is

fully inserted into the microphone/instrument output connector and the T1 input connector.

• Check the settings (if any) on your microphone or instrument.

• Check the batteries (if any) in your instrument or microphone.

Problem What to do

1 2 ... 53 54 55 56 57 58 59 60 61 62

No comments

Bose T1 User Manual Page 58