Bose Wave SoundTouch User Manual download pdf (Page 26)

26 - English

Maintaining Your Wave® SoundTouch™ Music System

Replacing the remote control battery

WARNING: Keep the remote control battery away from children. It

may cause a ﬁre or chemical burn if mishandled. Do not recharge,

disassemble, heat above 212ºF (100ºC), or incinerate. Dispose of a

used battery promptly. Replace only with a battery of the correct type

and model number.

CAUTION: Danger of explosion if battery is incorrectly replaced.

Replace only with an agency-approved (e.g. UL) CR2032 or

DL2032 3-volt lithium battery.

1. Place the remote face down on a ﬂat surface.

2. Using your ﬁnger, push the tab lock to the side as shown and

hold. Slide the battery compartment open.

See operating

instructions for

types of

battery to be used

e operating

nstructions for types of

battery to be used

WARNING: Do not ingest battery, chemical burn hazard. The remote

control supplied with this product contains a coin/button cell battery.

If the coin/button cell battery is swallowed it can cause severe internal

burns in just two hours and can lead to death. Keep new and used

batteries away from children. If the battery compartment does not

close securely, stop using the product and keep it away from children.

If you think the battery may have been swallowed or placed inside any

part of the body seek immediate medical attention.

3. Remove the old battery and install the new one with the plus

(+) symbol facing up.

See operating

instructions for types of

battery to be used

4. Gently slide the battery compartment closed. It locks

automatically.

Alternate setup method

Using this method you can set up your Wave

SoundTouch™

music system by ﬁrst joining its own built-in Wi-Fi

network, and

then connecting to your home Wi-Fi network.

Note: Use this method to set up your system as an AirPlay device,

only. To access the beneﬁts of SoundTouch™, such as

streaming Internet radio and your music services, you must

add the system to your home Wi-Fi network using the

SoundTouch™ app (see page 9).

1. On the Wave

SoundTouch™ music system remote, press the

Power button to turn on the system.

2. On the back of the SoundTouch™ pedestal, press and

hold the Control button for about two seconds until

ALTERNATE SETUP is displayed on the front panel.

3. On your smart device, activate Wi-Fi and join the Bose

SoundTouch™ Wi-Fi Network.

4. Open a browser and type: http://192.168.1.1 in the address

ﬁeld.

The Wi-Fi setup window appears on the screen.

5. Select your home Wi-Fi network from the drop-down list.

6. Enter your password (if required) and tap or click Connect.

The SoundTouch™ pedestal attempts to connect to your home

Wi-Fi network.

The Wi-Fi indicator on the rear panel of the SoundTouch™

pedestal momentarily blinks white and then turns solid white

when connected to the network.

7. On your computer, tablet or smartphone, return to the Wi-Fi

control panel and rejoin your home Wi-Fi network.

8. Once the system is on the network, follow these steps to

complete setup:

A. Download and launch the SoundTouch™ app. See

"Installing the SoundTouch™ app" on page 9.

B. On the SOUNDTOUCH™ SYSTEM SETUP screen, select

this option:

IT IS ALREADY ON MY NETWORK

Disable/enable Wi-Fi capability

The SoundTouch

pedestal has built-in Wi-Fi capability that

enables it to wirelessly connect to your home Wi-Fi network.

To disable Wi-Fi, press and hold the Control button on the back of

the SoundTouch

pedestal for at least eight seconds or until the

Wi-Fi status indicator turns off.

To enable Wi-Fi again, turn on the system.

Power Saving mode

The SoundTouch

™

pedestal has a low-power standby mode in

which it consumes a minimum amount of power. This can be used

to reduce the power consumed in your home while you are away.

To place the SoundTouch

pedestal in the Power saving mode,

press and hold the Control button on the back of the SoundTouch

pedestal for at least eight seconds or until the Wi-Fi status indicator

turns off. This also disables the Wi-Fi capability.

To wake up the SoundTouch

pedestal, quickly press and release

the Control button. The Wi-Fi capability is enabled again when any

source is selected.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 32

Comments to this Manuals

No comments

Bose Wave SoundTouch User Manual Page 26

Comments to this Manuals

Related products and manuals for Alarm clocks Bose Wave SoundTouch