Bose Aviation Headset X Technical Information download pdf (Page 11)

ETTING YOUR HEADSET READY FOR USE

Before you remove or attach the microphone, however, be sure to

note the important markings for left (L) and right (R) above each

earcup. These markings indicate which ear each earcup is intended

to fit over.

Removing an attached boom microphone cable

1. Use a Phillips or straight blade screwdriver to loosen the two

screws at the base of the boom microphone cable assembly.

2. Pull the cable assembly straight out from the earcup to which it

attached (Figure 6).

CAUTION:

Do not twist the boom microphone cable while disconnecting it.

Twisting can damage the connector pins.

Figure 6

Pulling the cable assembly

straight out from the earcup

Access

cover

Connector

pins

Cable

assembly

Connector

pins

L for left

Attaching the boom microphone cable

Before you attach the boom microphone, make sure that the cable

connector and its earcup connector are clean and free of debris.

1. Use a Phillips or straight blade

screwdriver to loosen the two

screws on the access cover near the bottom of the earcup where

you want to attach the boom microphone.

2. Remove the cover to reveal the connector pins on the earcup.

3. Carefully line up the connector to the small connector pins on

e panel (Figure 7 on page 12).

CAUTION:

An improperly aligned connector will not make the connections

necessary for proper operation, and may cause damage.

00_AM270261-01_HeadsetXII.book Page 11 Tuesday, August 11, 2009 2:27 PM

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 35 36

No comments

Bose Aviation Headset X Technical Information Page 11