Bose Aviation Headset X Technical Information download pdf (Page 15)

ETTING YOUR HEADSET READY FOR USE

CAUTION: Do not attempt to pull the connector out without first pulling

back on the sleeve. Forcing the connector out

will cause damage to the cable

and/or your aircraft instrument panel.

Figure 11

Attaching and removing the

cable

Slide sleeve

to release

Align keyway

Mounting the connector

Mount the connector into a cutout, as shown in Figure 12 below.

Connect the eight wires as follows:

• Two for the microphone

• Two for audio

•One for power

• One for ground

• Two for audio shields

Audio and microphone wires should be connected to the back of the

isting microphone and headphone jacks, leaving existing jacks

intact for use with conventional headsets. This is usually the fastest

installation method (see Figures 1 – 4 for reference). Audio shields

should be connected to ground at the existing jack.

(Caution: Use of two headsets wired in parallel is

not advised. This

may result in reduced performance.)

Figure 12

Harness connector and

schematic

12.5mm

.49"

.55"

14.0mm

Pin 6

Pin 1

Backnut

Front Nut

M14 X 1

Hex Nut

RED

•

1 V+IN

BLK

•

2 GND

WHT

•

3 COMM L

BLU

•

4 COMM R

WHT

•

5 MIC HI

WH/BLU

•

6 MIC LO

BLK/WH

Panel Hole

Required

Receptacle -

Pinout

(Front View)

Receptacle -

Backnut

(Side View)

Aircraft

Interface

Schematic

00_AM270261-01_HeadsetXII.book Page 15 Tuesday, August 11, 2009 2:27 PM

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 35 36

Comments to this Manuals

No comments

Bose Aviation Headset X Technical Information Page 15

Comments to this Manuals

Related products and manuals for Soundbar speakers Bose Aviation Headset X