Bose FreeSpace E-4 Specifications download pdf (Page 49)

49 of 80

6.0 E4 System Setup

6.3.4 Source assign

In the Source Assign control, you can choose which system

sources will be available in each zone. The Source Assign control

panel lists all system sources on the left and zone sources on the

right. Sources are assigned by moving them from the System

Sources list to the ZONE Sources list.

Factory default settings

Programmer’s Notes:

• Because the E4 hardware is a router, at least one

source must always be assigned to a zone.

• If you try to remove all sources from a zone, the last

active source will always remain assigned to the zone.

• This function is disabled for zones in which Auto Volume

is enabled (On). If you turn Auto Volume off and change

source assignments, you will need to recalibrate Auto

Volume.

• Any source assigned to ZONE 4 will also be sent to the

AUX OUT/CONTROL output.

To assign a source to a zone

1. Select a source in the System Sources list.

2. Click the right arrow () button to move the highlighted

selection to the ZONE Sources list.

When the source appears in the ZONE Sources list, it is

assigned to the current zone. Once a source is assigned to a

zone, that source is no longer available in the System

Sources list and appears grayed out.

To unassign a source

1. Select the source in the ZONE Sources list.

2. Click the left arrow () button to move the highlighted selec-

tion to the System Sources list.

To route a source to a zone

Double-click on the source in the ZONE Sources list. When the

source is routed, a sounding-speaker icon appears next to the

source.

Programmer’s Note: The FreeSpace

Installer™

software automatically disables keys of unassigned

sources when a Flash Hardware Configuration

command is performed.

LINE 1 input source is assigned and routed to all four zones.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 74 75

No comments

Bose FreeSpace E-4 Specifications Page 49