Bose 141 Series II User Manual download pdf (Page 5)

English

– + +–

Setting Up

Test the speakers

To make sure your speakers operate correctly:

1. SetyourreceiverorampliertoMONO(monophonic)andturniton.

2. Setthebalancecontroltonormal(centerposition).

3. Placethespeakerslessthan6inches(15cm)apart,facingeachother.

4. Play some deep bass passages of music through the speaker.

The sound should seem to come from a point between the two speakers. The bass should

be full and natural. If it is not, your connections may be out of phase. To make them match

connectionstotheamplier,tryreversingthe+and–connectionsonthebackofone

speaker.Thenrepeatsteps1–4.

Figure 3

Completed connections

Check the connections

Checktobesureallconnectionsaremadepositivetopositive(+to+)andnegativeto

negative(–to–).Makesurethatnoloosestrandsofwiretouchacrossterminals.Loosewire

strands could short circuit, which can result in electrical shock or damage. Tighten any loose

connections before you plug in the receiver or ampliﬁer and turn it on.

–

Amplierorreceiver

1 2 3 4 5 6 7 8

No comments

Bose 141 Series II User Manual Page 5