Bose Solo User Manual download pdf (Page 26)

Disassembly Procedures

1. PCB Cover Removal

1.1 Remove the 6 screws indicated in Figure 3.

1.2 Lift off the PCB Cover

2. Main PCB Removal

2.1 Perform procedure 1.

2.2 Remove the 5 screws indicated in Figure 4.

2.3 Disconnect the 2 cable connectors and 1 ribbon

cable from the Main PCB.

2.4 Pull off the bass knob from the rear of the unit.

Note: When replacing the bass knob, hold the bass

POT while pressing on the knob to prevent applying

excess pressure to the solder connections on the

POT.

2.5 Lift up on the front of the PCB and then pull it

forward so the rear connectors clear the enclosure

openings.

Note: When replacing the Main PCB, ensure the

ground wire is secured as shown in figure 4. Also,

ensure the speaker wire harness is located in the

channel shown in figure 4.

3. Top Cover Removal

3.1 Perform procedure 1 and 2.

3.2 Remove the 31 screws indicated in Figure 5. 13

screws inside the PCB well and 18 screws around the

perimeter of the unit.

3.3 Flip the unit over and slowly lift off the top cover.

Use care to prevent the gasket from being pulled away

with the top cover. The gasket should remain in the

channels of the enclosure.

Note: There is no replacement gasket available.

Figure 3. PCB Cover Removal

Figure 4. PCB Removal

Figure 5. Top Cover Removal

Ground wire

Speaker wire

harness

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 32 33 34

No comments

Bose Solo User Manual Page 26