Bose VIRTUALLY INVISIBLE 191 User Manual download pdf (Page 16)



TEPS TO INSTALLING

EnglishFrançaisNederlands DeutschItaliano

Figure 18

Pulling the wire up and out,

to the left (a) and securing it

with tape (b).

At least 14 in.

(36 cm) of wire

(a) (b)

2. Use tape to temporarily affix the loose end of the wire above and to the left of the hole

(Figure 18b). This keeps the wire out of the way until you have the speaker partially

inserted in the wall and are ready to make the connections.

Insert the speaker into the opening

Before you follow the steps below, check to be sure none of the dogleg clamps (two on each

side) are protruding from behind the frame of the speaker. If they are, press them back behind

the frame so the speaker will fit into the hole.

7LSLoosen the screw terminals on the upper left side of the speaker before inserting the

speaker into the hole to save effort in making the connections.

1. Use both hands to support the speaker and angle it slightly, so it is diagonal to the hole.

This allows clearance for the wall stops.

2. Insert the bottom of the enclosure through the hole and down part of the way – or up,

depending on your clearance issues (Figure 19).

Figure 19

Partially inserting the

rectangular-faced or round-

faced speaker

Dogleg clamps

Wall stop

3. Leave the speaker in this partially inserted position, resting on the wall stops that prevent

it from falling out (Figure 20). This allows ready access to the connection terminals on the

upper left-hand side of the speaker.

Figure 20

Speaker held in place by

wall stops

Wall stop

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 143 144

No comments

Bose VIRTUALLY INVISIBLE 191 User Manual Page 16