Bose 3.2.1 Series III User Manual download pdf (Page 24)

SETUP

ItalianoSvenska DeutschNederlands EnglishFrançais Español

To get digital audio from the component

For a component that is already connected to the

media center, you can make a digital audio connection

too.

For this higher quality audio, you need a digital audio

cable that works with your component. Such cables are

available at most electronics stores.

1. Identify the digital connector on your component

as either an Optical or Coaxial connector.

2. Be sure to use the right cable for this connector.

Note: If your component has an Optical and a Coaxial

connector, use either one but not both.

3. Connect one end of your digital cable to the digital

AUDIO OUT connector on your component.

Be sure to keep the red and white audio cable

connected. This allows you to hear the audio if the

program audio is not digital or the digital signal is

interrupted.

4. Locate the appropriate digital AUDIO IN connector,

labeled D, on the system media center.

You can make:

• up to 3 coaxial connections

• up to 2 coaxial and one optical connection

Note: The media center Optical connector is factory

set to work with a cable or satellite box. If your Optical

component is neither of those, you need to select your

component in an on-screen System menu. See

“Getting digital audio from a source” on page 45.

Coaxial

Optical

Optical OR Coaxial

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 107 108

No comments

Bose 3.2.1 Series III User Manual Page 24