Bose Acoustimass 15 Specifications download pdf (Page 9)

AM194452_06_V.pdf October 22, 2001 7

Setting Up

Connect the speakers

Connect the cube arrays to the Powered Acoustimass

module, and then connect the

module to your receiver. The supplied cables make this easy. The cables may be separated

or “unzipped” as much as needed to comfortably reach the speakers. See Figure 4.

Figure 4

Separating cables

CAUTION:

Before making any connections turn off your receiver and unplug it from the

outlet (AC power mains). Not doing so may result in damage to your system.

CAUTION:

Never connect the cubes directly to a receiver output. Always connect the cube

arrays to the Powered Acoustimass module, then connect the module to the receiver.

CAUTION:

Never use broken or frayed wiring, which can result in electrical shock or

damage to your system. The supplied cables are not intended for in-wall installation. Check

local building codes or enlist a qualified installer.

Connect the Powered Acoustimass module to the center and

front cube arrays

Three individual 20 (6m) foot wire pairs connect the Powered Acoustimass module to the

Center, Right, and Left front cube arrays. Each cable connects to the module with a single

plug.

1. Connect the wire pair marked C to the center speaker. Just press the terminal tab on the

back of the cube array to insert the marked wire into the red terminal and the plain wire

into the black terminal. See Figure 5. Release the tab to secure the wires.

2. Connect the wire pair marked R to the right front speaker (to the right of the TV as you

face it).

3. Connect the wire pair marked L to the left front speaker.

Figure 5

Making cube speaker connec-

tions

Marked wire

to Red terminal

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 17 18

No comments

Bose Acoustimass 15 Specifications Page 9