Bose Cinemate Technical Information download pdf (Page 12)

SYSTEM SETUP

EnglishFrançais Español

Note: On 220-240V models only, turn the Acoustimass

module POWER switch to on (l).

Figure 13

Power cord as the final

connection

Note: Bose recommends using a safety agency-approved surge protector on all electronic

equipment. Voltage variations and spikes can damage electronic components in any system.

A quality suppressor can eliminate the vast majority of failures attributed to surges and may be

purchased at electronics stores.

Standby and Power LED indicators

Once you have connected the CineMate

™

system to a power source, the red LED on the front

of the Interface module will light, indicating that the system is in Standby mode.

When the system is powered on, the green LED on the front of the Interface module will light.

The green LED will flash each time the Interface module receives a command from the

remote.

Figure 14

Standby and power LEDs

on the Interface module

AC power switch

Provided on 220-240V

rated systems only

115/230V selection switch

Provided on 115/230V

dual-voltage rated systems only

AC power

connector

Power LED (green) Standby LED (red)

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

No comments

Bose Cinemate Technical Information Page 12