Bose Acoustimass 10 Speakers Technical Information download pdf (Page 10)

SETTING UP

EnglishFrançais Español

Figure 8

Acoustimass

module to

receiver connections

Thumbscrews

Home theater

receivers

Acoustimass

module

LFE connector with

cover removed

Checking the connections

Before plugging in the Acoustimass module, check all connections from the receiver to the

the module and the module to the small speakers (Figure 8).

• Make sure all cube speaker arrays are connected to the proper terminals according to their

position in your room.

• Check to be sure all wires are connected to your surround receiver with the proper polarity

(+ to + and – to – wires). Incorrect wiring can result in a total loss of module output.

• Correct any wiring problems before you plug in your receiver and turn it on.

When all the connections check out, plug the power cord from the Acoustimass module into

an AC (mains) outlet. Plug in the receiver also.

Note:

Bose recommends using a quality surge suppressor on all electronics equipment.

Voltage variations and spikes can damage electronic components in any system. Using a high-

quality suppressor (available at electronics stores) can eliminate the vast majority of failures

caused by a power surge.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

No comments

Bose Acoustimass 10 Speakers Technical Information Page 10