Bose Freestyle Technical Information download pdf (Page 10)

System Setup

Making system connections

Labeled jacks on the rear of the Acoustimass

module and the custom cables supplied with

the system ensure a fast and easy hookup.

CAUTION:

Do not plug the Acoustimass module into an AC power (mains) outlet until all the

source components are connected to the Interface module.

Follow these basic steps

1. On the rear panel of the Acoustimass module, insert the single-plug end of the speaker

cable into the SPEAKERS connector (Figure 9). Firmly tighten the two screws on the

connector.

Figure 9

Speaker cable connection

to the Acoustimass module

2. At the other end of the speaker cable, grasp the two connectors and pull the cable apart

as much as necessary to reach each speaker.

3. Plug the LEFT connector of the separated cable into the rear jack on the left speaker (to

the left of the TV as you face it) and the RIGHT connector into the rear jack on the right

speaker (to the right of the TV). LEFT or RIGHT is printed on the appropriate connector

(Figure 10).

Figure 10

LEFT and RIGHT markings

on the speaker connectors

4. On the Acoustimass module, insert the Interface module connector into the jack labeled

with an input symbol (Figure 11). Firmly tighten the two screws on the connector.

Figure 11

Interface cable connector

Note:

Longer speaker cable is available from Bose, if you need it. To contact Bose to order it,

refer to the address sheet included in the carton.

SPEAKERS

RIGHT

LEFT

Screws

RIGHT

LEFT

SPEAKERS

Screws

AM267190_00_V_pdf • July 24, 2002

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

No comments

Bose Freestyle Technical Information Page 10