Bose VCS-30 Series II Technical Information download pdf (Page 11)

AM257528_01_V.pdf October 26, 2001 11

Setting Up

Mounting your speakers on a wall

CAUTION:

Do not mount the brackets on surfaces that are not

sturdy enough, or that have hazards concealed behind them,

such as electrical wire or plumbing. If you are unsure about install-

ing the bracket, contact a qualiﬁed professional installer.

CAUTION:

Do not hang items from the brackets or speakers. The

brackets were designed to support the weight of the speakers

only.

Note:

See the back pages of this guide for the mounting template

and hardware information.

Note:

For vertical mounting, mount part A with the hole for screw

C at the bottom. Be sure to tighten all screws.

Note:

For Stereo Everywhere

speaker performance, horizontal

mounting is required.

1. Hold the mounting template in position and mark holes for the

mounting hardware. If you plan to feed wires through the wall,

mark the speaker wire pilot hole also.

2. Drill holes for the chosen mounting hardware.

3. Mount bracket part A to the wall and mount bracket part B to

the rear of the speaker (Figure 8).

4. Secure the speaker with bracket part B to bracket part A

using screw C. To adjust the angle, loosen screw C slightly,

move the speaker up or down, and retighten screw C.

Figure 8

Speaker-bracket

installation

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18

No comments

Bose VCS-30 Series II Technical Information Page 11