Bose 550 Instruction Manual download pdf (Page 27)

XD-750/700/550/500 (En)

Preparation section Basic section Application section Knowledge sections

Selection of DOLBY NR

(Noise Reduction)

To end recording

Selection of the reverse mode

÷Pressing the key pauses recording after leaving a non-recorded

space of about 4 seconds.

÷If the key is pressed again in less than 4 seconds after it has been

pressed, recording resumes from that instant.

1Play (or tune) the input source to be

recorded.

2Start recording.

4. Select the source to be recorded.

5. Start recording.

÷When the CD input is selected and if a disc

has been set in the CD player, its playback

starts immediately.

The Dolby NR system minimizes the hiss noise heard when

playing tape. When playing a tape prerecorded with Dolby

NR ON, be sure to set the DOLBY NR ON for playback.

DOLBY NR

Lit when “DOLBY NR” is ON.

Each press switches the modes as follows.

1 “[”... Both sides are played back (recorded), and

then the tape stops.

2 “”” .. Both sides are played back endlessly.

(The tape stops after recording onto both

sides.)

3 ““” .. Only one side is played back (recorded),

and then the tape stops.

Each press switches the modes as follows.

1 “DOLBY NR” ON. ..... DOLBY NR is used.

2 “DOLBY NR” OFF ..... DOLBY NR is not used.

Let's record

REV. MODE

REC/ARM

ECHO

TAPE

BASS

DOLBY NRDOLBY NR

Select an input source other than “TAPE”.

INPUT

REC/ARM

÷Recording stops automatically when the tape

side(s) to be recorded have been fully recorded.

÷ The beat cancel function can be used when

recording MW broadcasts.

•

REV

CD)1 )))

BASS

:

The input source component to be recorded should be displayed.

REV.MOD

CD  )1  3628

BASS

:

TOTAL

Lights

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 59 60

Comments to this Manuals

No comments

Bose 550 Instruction Manual Page 27

Comments to this Manuals

Related products and manuals for CD players Bose 550