Bose Personalized Amplification System Setup Guide download pdf (Page 11)

SYSTEM SETUP

TAB English TAB TAB 4, 11 TAB 5, 12 TAB 2, 9, 16 TAB 1, 8, 15

Extending the Loudspeaker Array

Once you have set the system in place:

1. Slide the Loudspeaker Array up and out of the Power Stand and temporarily lay

it aside.

Note: The two L1

Compact Extensions are identical to each other. Either one can

be used on the top or bottom, but if one extension is used, both must be used.

2. Align the plug on the bottom of the Extension with the socket on the Power

Stand, then slide the extension into the power stand.

Be sure to fully insert the extension into the Power Stand socket to assure

stability and a good connection.

3. Align the remaining Extension and push it firmly in place.

4. Align the Loudspeaker Array and push it firmly in place.

Connecting power to the system

1. Make sure the power switch is off (down position).

2. Plug one end of the power cord into the connector on the power stand.

3. Plug the other end into a live electrical receptacle.

4. Before turning the system on, connect your sound sources. See “Operating

Information” on page 6, and “Plugging in your sources” on page 7.

CajunOG.book Page 5 Tuesday, December 16, 2008 10:13 AM

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

No comments

Bose Personalized Amplification System Setup Guide Page 11