Bose VCS 10 Series II User Manual download pdf (Page 14)

12 October 22, 2001 AM19464_02_V.pdf

English

Setting Up

Check the connections

Check all connections from the receiver to the Acoustimass

module and the module to the

cube speakers (Figure 9). Make sure all speakers are connected to the proper terminals

according to their position in your room.

At the receiver, check that the wires are connected in phase (+ to + and – to –). Incorrect

wiring can result in a total loss of Acoustimass module output.

Be sure to correct any wiring problems before you plug your receiver in and turn it on.

CAUTION:

Do not allow exposed wires to brush against each other; this could damage

your receiver.

Figure 9

Completed connections

SURROUND SPEAKERS

R CENTER

FRONT SPEAKERS

LREAR

INPUTS

LEFT CENTER RIGHT LEFT RIGHT

SURROUND SURROUND

TO CUBE SPEAKERS

LCRLSRS

OUTPUTS

FROM RECEIVER OR AMPLIFIER

LCRLSRS

RCL

RS LS

Attach the module end cover, if desired

The module end cover is designed to hide the cabling and extend the smooth, clean lines of

the Acoustimass module. However, because the cover has a beveled surface, you cannot

stand the module on that end with the cover in place.

If you plan to use the cover, attach it to the cable end after all connections have been

checked (Figure 9). Gently push the end cover into the grommets on the Acoustimass

module (Figure 10).

Your set-up is complete. Enjoy your Acoustimass 10 Series II speaker system.

Figure 10

The module end cover fits over

the cables

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20 21

No comments

Bose VCS 10 Series II User Manual Page 14