Bose Cinemate Cinemate Digital Home Theater Speaker System Setup Guide download pdf (Page 34)

14 – English

CARE AND MAINTENANCE

Pairing the Acoustimass

module with the speaker array

Your speaker array and Acoustimass module are paired at the factory. However, should

you ever need to pair them for any reason, do the following:

1. Unplug the Acoustimass module AC power cord.

2. Remove the door on the end of the speaker array.

3. Press and hold the ADAPTiQ

button for 3-4 seconds until the status indicator starts

slowly blinking orange.

4. Plug the Acoustimass module AC power cord in the AC outlet.

Pairing is complete when the Acoustimass module status indicator becomes solid

orange and the speaker array status indicator turns off.

Replacing the remote batteries

Replace both batteries when the remote control stops operating or its range seems

reduced. Alkaline batteries are recommended.

1. Slide open the battery compartment cover on the back of the remote.

2. Remove both batteries.

Be sure to dispose of the batteries according to the regulations in your area.

3. Insert two AA (IEC-LR6) 1.5V batteries, or the equivalent. Match the + and – symbols

on the batteries with the + and – markings inside the compartment.

4. Slide the battery compartment cover back into place.

Cleaning your speaker system

• You can clean the surface of the speaker array and Acoustimass

module with a soft,

dry cloth.

• Do not use any sprays near the speaker array. Do not use any solvents, chemicals,

or cleaning solutions containing alcohol, ammonia, or abrasives.

• Do not allow liquids to spill into any openings.

• The speaker grille requires no special care, although you may carefully vacuum it with

a brush attachment, if necessary.

Battery cover

AA (IEC LR6)

batteries (2)

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 82 83

No comments

Bose Cinemate Cinemate Digital Home Theater Speaker System Setup Guide Page 34