Bose 3.2.1 GSX Specifications download pdf (Page 47)

47

DISASSEMBLY PROCEDURES

Standard Satellite Array Procedures

Notes:

• The standard satellite arrays are non-

repairable. These are the arrays that have

the cloth grilles, and are physically larger

than the Gemstone

TM

array.

• The only parts that can be replaced on the

standard arrays are the grille and the name-

plate. Refer to the photos at right for the

following procedures.

1. Grille Removal

1.1 Wrap some masking tape around the

shaft of a flat-tip screwdriver approximately

1/2" back from the end. This is needed to

protect the plastic enclosure of the array.

1.2 Place the satellite array on its back on a

bench. Use your thumb to press down on

the array grille at the center of the curve

near the side. At the same time, use the

screwdriver to pry the end of the grille off of

the array enclosure. Repeat this at the other

end of the grille.

Re-Assembly Note: Align the grille so that

the Bose

®

logo is facing the same direction

as the arrows on the front of the array

enclosure. Press the grille in place. It should

latch to the enclosure at each end.

Gemstone Satellite Array Procedures

1. Grille Removal

1.1 Using a scribe or small flat-tip screw-

driver, grasp the edge of the grille. Gently

pull the grille away from the enclosure.

2. Driver Removal

2.1 Perform procedure 1.

2.2 Using a Phillips-head screwdriver,

remove the four screws that secure the

driver to the enclosure. Lift the driver out of

the enclosure and cut the wires as close to

the driver as possible.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 67 68

Comments to this Manuals

No comments