Bose Acoustimass 10 Series I Technical Information download pdf (Page 12)

12 December 20, 2001 AM183644_01_V.pdf

Maintaining Your Acoustimass

-10 Speakers

Troubleshooting

If you have a problem with your Acoustimass-10 speakers, turn off your sound source and

try the solutions below. If you still have a problem, contact your Bose

dealer to arrange for

service. Or, to contact Bose directly, refer to the inside back cover of this guide.

Problem What to do

• Make sure speaker cable is not damaged.

• Reduce the volume of any external components connected to

the receiver.

• To get the full performance benefit, your Acoustimass-10

speakers must be connected to a HiFi Stereo VCR or Stereo

television.

No bass

• Move the Acoustimass module closer to a wall or corner to

increase bass. Move it farther from a wall or corner to decrease

bass.

• Make sure the speaker connections at the receiver or amplifier

are correct (+ to + and - to -). If you are using in Dolby Pro-Logic

mode, check that surround sound is turned ON. If you are using

AC-3 programming, verify that the settings are correct at the

receiver. Be sure the source material (laser disk or broadcast

programming) is Dolby AC-3 encoded.

Not enough or too

much bass

No stereo sound

System does not

function at all

• Make sure the power cord of the receiver is plugged into an

operating AC wall outlet and that the unit turned on.

• Be sure to select a source at the receiver (video, CD, tuner).

• Check the speaker connections. Turn the unit ON.

• Increase the volume.

• Disconnect any headphones.

Sound is distorted

No sound

Customer service

For additional help in solving problems, contact Bose customer service. See the inside back

cover for Bose customer service offices and phone numbers.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18

No comments

Bose Acoustimass 10 Series I Technical Information Page 12