Bose bose am268612_00_v User Manual download pdf (Page 7)

Setting Up

Figure 6

Connecting cord to receiver

Checking the connections

Check the speaker connections carefully. Make sure no loose strands of wire touch across

terminals. This could create short circuits and damage an ampliﬁer or receiver.

Tighten any loose connections before you plug in the receiver/ampliﬁer.

Testing the connections

To make sure your speakers operate correctly, follow these steps:

1. Center the balance control on your receiver/ampliﬁer.

2. Set the stereo/mono control to MONO.

3. Play some passages of music containing deep bass through the speakers.

The sound should seem to come from a point between the two speakers. The bass should be

full and natural. If not, the connections may be reversed, causing the speakers to play out of

phase. To correct the problem, make sure all the cords are connected positive to positive (+

to +) and negative to negative (– to –).

AM268612_00 _V.pdf • January 10, 2003

1 2 3 4 5 6 7 8 9 10 11 12 ... 18 19

No comments

Bose bose am268612_00_v User Manual Page 7