Bose VCS-10 User Manual download pdf (Page 13)

Adjusting Your Surround Sound Settings

How to set your Dolby Digital receiver

Your VCS-10

or VCS-30

Series II speakers are compatible with

the output from Dolby Digital receivers. Take special care to set

the channel output on the Dolby Digital screen menu to SMALL for

both the center speaker and surround speakers.

Follow the receiver owner’s guide instructions for using the

receiver test tone to verify your connections and to adjust the vol

ume levels of the speakers.

If the sound is interrupted

The VCS-10 Center Speaker and VCS-30 Series II Center/Sur-

round Speaker System feature an advanced automatic electronic

protection circuit to prevent speaker damage due to an overload.

When the center channel speaker detects an overload, the protec-

tion circuit intermittently shuts down and resets the speaker a

fraction of a second later, until the overload is cleared. Intermittent

play will continue for the duration of the overload.

If you hear this interruption, turn down the volume to relieve the

overload. You will hear the speaker resume normal play when the

volume is set at a safe level.

Note: The overload problem described here should occur only if

the receiver is overdriven and sending a distorted signal, or when

the center speaker is driven by an amplifier rated well above the

100 watts per channel maximum listed in

“Compatibility” on

page 15.

Receiver channel output Proper setting

Center SMALL

Left and right surround speakers

(VCS-30 Series II surround speakers)

SMALL

1 2 ... 8 9 10 11 12 13 14 15 16 17

No comments

Bose VCS-10 User Manual Page 13