Bose Acoustimass 10 V Technical Information download pdf (Page 11)

English - 11

Using Your System

Setting your digital surround sound receiver

Speakers in your Acoustimass

6 series V or Acoustimass 10 series V system are fully compatible with the audio output of digital

surround receivers. The system’s integrated signal processing supports full low-frequency reproduction from all channels.

To gain complete advantage of these system capabilities, you may want to adjust some settings on your receiver. To make changes,

use the digital display menu on the receiver and refer to the list of recommended settings below.

Speaker Receiver setting

Left and right LARGE

Center LARGE

Left and right surround LARGE

LFE/Subwoofer ON

Note: If your receiver provides it, the LFE or Subwoofer option setting should be ON and the crossover value at the lowest number

possible, which is typically 80 Hz.

Receiving a digital audio signal

For the digital audio signal from additonal sources (Blu-ray

™

or DVD player, CBL/SAT box, gaming system, etc.) to reach your surround

receiver, you need a digital audio connection between the additonal source and receiver.

• Use either the HDMI

™

, Optical or Coaxial input on the receiver to connect to the digital output from the additional source. Do not use

more than one connection.

• Be sure to select the digital output in the setup menu of your additional source.

For additional setup and operating information, please refer to the owner’s guide that came with your surround receiver.

HDMI

Setting your analog surround sound receiver

For analog (non-digital) surround sound applications, we recommend that you set the surround sound center mode of your receiver to

Wide. For instructions on how to change this setting, refer to the owner’s guide provided with your surround receiver.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 43 44

No comments

Bose Acoustimass 10 V Technical Information Page 11