Bose ControlSpace ESP-88 User Manual download pdf (Page 10)

Bose

ControlSpace

™

ESP-88 Quick Start Guide

Troubleshooting

The Status LED on the front panel is off. Make sure the ESP-88 is plugged in

properly and powered on. Use

ControlSpace Designer software to

load a configuration.

I cannot see checkboxes in the Update

Firmware window.

Press Scan again until a horizontal

scroll bar appears in the dialog and

use it to slide the window to the left.

After updating firmware, the Firmware

Update window does not show that all

devices are “up-to-date.”

Power cycle the ESP-88 and press

the Scan button in the Update

Firmware window.

After pressing Scan, I receive one of the

following errors:

[Error 1]There is no ESP-88 in this

network.

[Error 2]Numbers of ESP-88 in the

network is different from settings in the

software.

[Error 3]IP address of ESP-88 in the

network is different from settings in the

software.

Make sure the ESP-88 is properly

connected to your network. Try power

cycling the ESP-88.

When dragged into Project View, an ESP-

88 or CC-64 does not show up, but

loudspeakers and amps do show up.

Change your regional settings to

English language. ControlSpace

Designer

™

software will not work

properly with non-English language

regional settings.

- 10 -

1 2 ... 5 6 7 8 9 10 11

Comments to this Manuals

No comments

Bose ControlSpace ESP-88 User Manual Page 10

Comments to this Manuals

Related products and manuals for Recording Equipment Bose ControlSpace ESP-88