Bose ControlSpace ESP-88 Installation Guide Page 10

  • Download
  • Add to my manuals
  • Print
  • Page
    / 14
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 9
10
Technical Specifications
Type 8 analog, electronically balanced, micro-
phone/line level (software selectable)
Connectors Phoenix/Euroblock 2-piece, 3-pin
Nominal input +4dBu/-10dBu/-20dBu/-38dBu/
level -44dBu/-50dBu/-60dBu
Frequency 20 to 20kHz (+0.5dB / -2.0dB ) at
response +4dBu nominal input level
Input impedance 2.4K ohm @ 1kHz (with or without
phantom power active)
Maximum input +24dBu at +4dBu nominal input level
level
Equivalent input -115dB at -60dBu nominal input level
noise (A-weighted/20-20kHz)
Dynamic range 104dB (typical) at +4dBu nominal input
level (A-weighted/20-20kHz)
Phantom power +15V nominal, selectable per input
THD+N 0.01% at +4dBu nominal input and
output level (A-weighted/20-20kHz)
Digital resolution 24-bit
Inputs
Type 8 analog, electronically balanced
Connectors Phoenix/Euroblock 2-piece, 3-pin
Nominal output +4dBu
level
Output impedance 200 ohms (600 ohm load expected)
Frequency response 20 to 20kHz (+0.5dB/-2.0dB ) at +4dBu
nominal output level
Maximum output +24dBu at +4dBu nominal output level
level
Digital resolution 24-bit
SNR 80dB at +4dBu nominal output level
(A-weighted/20-20kHz)
Residual output -110dBu at output muted
noise (A-weighted/20-20kHz)
THD+N 0.01% at +4dBu nominal input and
output level (A-weighted/20-20kHz)
Crosstalk < -90dB at +4dBu nominal input and
output level 1kHz
Outputs
Signal processing
Type 8 analog or digital inputs, 5.1k ohms
internal pull-up resistor to 5V
Connectors Phoenix/Euroblock 2-piece, 9-pin
3.81mm pitch
Analog input 0V to 3.3V (Max 5V; suitable for
10k ohms variable resistor
Digital input 0V to 3.3V (Threshold voltage =
voltage range 1.6V; internal 5.1k ohms pulled up
to 5V)
Control inputs
Type 8 digital outputs, 10k ohms
internal pull-up resistor to 5V
Connectors Phoenix/Euroblock 2-piece, 9-pin
3.81mm pitch
Output voltage 0V to 5V open collector
Output current 0.5mA (Source)/10mA max (Sink)
Control outputs
Type 32-bit floating-point digital signal
processor(s)
Clock speed 200MHz
Maximum 1600 MIPS/1200MFLOPS
calculation (6400MIPS/4800MFLOPS with DSP
option card)
Delay memory 16MByte/72s(Maximum)
(64MByte/288s(Maximum)
with DSP option card)
Audio latency 610us (analog in to analog out)
(860us with DSP option card)
Sampling rate 48kHz
LAN 10Base-T (RJ-45)
RS-232C
D-Sub 9 pin, male; DTE
RS-485
Phoenix/Euroblock 2-piece, 3-pin
Communication ports
Page view 9
1 2 ... 5 6 7 8 9 10 11 12 13 14

Comments to this Manuals

No comments