Bose Homewide Wireless Audio Link Link AL8 User Manual download pdf (Page 5)

INTRODUCTION

English Deutsch FrançaisDansk Español Italiano SvenskaNederlands

What distinguishes the two units

The connection panel on each unit identifies it by name: TRANSMITTER or RECEIVER. Two

Bose

link jacks and a Channel button further distinguish the transmitter.

For compatibility, the two units have a matching Setup Code, set at the factory with both

switches in the “down” position (Figure 2). A Status LED lights when each unit is plugged in

and the two units are communicating.

Figure 2

Connection

panels on the two

units

Receiver

Transmitter

ose

link jacks

Bose link jack

Channel switch

Status LED

Note: For information on the meaning of the different Status LED lights, refer to

“Check the indicators and settings” on page 9.

Choosing a place for each unit

Place the transmitter in the same room with the LIFESTYLE

system media center. Place the

receiver in the same room with your Bose

link expansion product.

Note:

Use of the audio link with products that are not Bose link-compatible requires an adapter

cable. For further information, refer to “Instructions for non-Bose or older Bose

products” on

page 8.

Considerations for positioning:

• Place each unit upright with all feet flat on a level surface, such as a floor, table, or shelf.

• Do not tip either unit on its side.

•Place each unit within 2 meters (7 feet) of the product to which it is connected (using the

supplied Bose link A cable).

•Keep the two units within 23

meters (75 feet) of each other.

• Be aware that the strongest signal direction is above and around, not below, 

the transmitter.

1 2 3 4 5 6 7 8 9 10 ... 13 14

No comments

Bose Homewide Wireless Audio Link Link AL8 User Manual Page 5