Bose Acoustimass 3 Series User Manual download pdf (Page 8)

6 October 22, 2001 AM252171_02_V.pdf

Connecting the cube speakers to the Acoustimass

module

Use the following steps to connect the cube speakers to the rear panel of the Acoustimass

module:

1. Select one pair of wires, and locate the terminal tab on the rear of the left cube speaker.

2. Press the terminal tab on the back of the speaker and insert the marked wire into the red

(+) terminal and the plain wire into the black (–) terminal (Figure 3).

3. Release the terminal tab to secure both wires.

4. Repeat this process with the other pair of wires and the right cube speaker.

CAUTION:

Do not connect your amplifier or receiver directly to the cube speakers. Cube

speakers must be connected directly to the Acoustimass module or damage will result.

5. Locate the terminals marked OUTPUTS TO CUBE SPEAKERS on the rear panel of the

Acoustimass module (Figure 4).

6. Connect the free end of the left cube speaker cable to the left (L) pair of terminals. Make

sure that the marked wire is connected to the positive (+) terminal and the plain wire is

connected to the negative (–) terminal.

7. Repeat step 6 for the right cube speaker cable, connecting its wires to the right (R) pair of

terminals.

Figure 3

Connecting the speaker cable

to the cube speaker

Setting Up Your Acoustimass

3 Speaker System

Connecting the Acoustimass module to your receiver or amplifier

Use the following steps to connect your Acoustimass module to your receiver or amplifier:

CAUTION:

Correct wiring is important. Incorrect wiring will result in little or no bass output

and could potentially damage the system.

1. Locate the terminals marked INPUTS FROM AMP OR RECEIVER on the rear panel of the

Acoustimass module (Figure 4).

2. Connect either end of one of the remaining speaker cables to the left (L) pair of input

terminals. Make sure that the marked wire is connected to the positive (+) terminal and the

plain wire is connected to the negative (–) terminal.

3. Connect either end of the final speaker cable to the right (R) pair of input terminals. Make

sure that the marked wire is connected to the positive (+) terminal and the plain wire is

connected to the negative (–) terminal.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 16 17

No comments

Bose Acoustimass 3 Series User Manual Page 8