Bose ControlSpace User's Guide download pdf (Page 83)

Bose

ControlSpace

™

Designer

™

Software User Guide

Chapter 4: Store system programming

Storing discrete parameters

To include only specific settings in the parameter set, use the Parameter

Set Nodes List and place a check mark next to the settings within the

block, as shown in Figure 4.22. For example, you may want your

parameter set to set the gain level of an input block, but not affect the

mute status. When this parameter set is invoked, only the selected

settings will be changed. The settings that are not checked are not part of

the parameter set and remain unchanged when the parameter set is

invoked.

Figure 4.22 - Include only the selected settings in the parameter set

You can also use the Parameter Set Nodes List to modify an existing

parameter set. Open the Parameter Set Nodes List and check or uncheck

the settings that you want to include in the parameter set.

Changing values in parameter sets

If you need to change the value of a setting that is part of a parameter set

(for example, a gain of -6 dB) you will need to change the setting in the

ESP-88 window, the re-drag the block into the parameter set. The values

of parameters are displayed but cannot be changed within the Parameter

Sets window.

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 220 221

No comments

Bose ControlSpace User's Guide Page 83