Bose ControlSpace User's Guide Page 24

  • Download
  • Add to my manuals
  • Print
  • Page
    / 221
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 23
Bose
®
ControlSpace
Designer
Software User Guide
14 Chapter 1: Configure the ControlSpace Designer network
Network setup
To view and change the IP address of a component on your system,
choose System > Network Setup to open the Network Setup window.
Figure 1.17 - Network Setup window
The network is automatically scanned for all connected hardware. If you
change your hardware configuration while the Network Setup window is
open, press the Scan button to refresh the connected components list.
Click on a device and press the Change to... button to change the IP
address of that device. Each ESP-88 and CC-64 in your system must
have a unique IP address. Use the following IP addresses for the ESP-88
and CC-64:
ESP-88 - 192.168.0.160 through .175
CC- 64 - 192.168.0.176 through .207
Note: You must use IP addresses within the above ranges, or the
hardware device will not be found on the network.
Device firmware
The ESP-88, CC-64, and CC-16 require firmware to control their
operation. Firmware is programming that is stored in Flash memory and is
not erased when the power is turned off. On occasion, it is necessary to
update this firmware to fix problems or improve features. This section
describes how to update the firmware using ControlSpace Designer
software.
Page view 23
1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 220 221

Comments to this Manuals

No comments