Bose ControlSpace User's Guide download pdf (Page 17)

Bose

ControlSpace

™

Designer

™

Software User Guide

Chapter 1: Configure the ControlSpace Designer network

Figure 1.7 - Press OK in both windows to effect changes

Note: You must press OK in both the TCP/IP Properties window AND the

Local Area Connection Properties window to effect your IP address

change.

If you are using at most one ESP-88 and one CC-64, you can now plug

the ControlSpace hardware devices and your computer into the Ethernet

hub to create your local network. If you are using more than one ESP-88

or more than one CC-64, you must properly set the hardware IP

addresses before plugging all the ControlSpace hardware devices into

the Ethernet hub to prevent a conflict. See Using more than one ESP-88

in the next section for more information.

IP addresses

ControlSpace Designer software uses Internet Protocol (IP) addresses to

identify the ESP-88s and CC-64s in your network. Each computer, ESP-

88 and CC-64 must have a unique IP address in your ControlSpace

Designer network.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 220 221

No comments

Bose ControlSpace User's Guide Page 17