Bose ControlSpace User's Guide download pdf (Page 128)

Bose

ControlSpace

™

Designer

™

Software User Guide

118 Chapter 6: Program GPI/O and Serial Input/Output

When you assign a signal processing block to a digital GPI, the Set Mode

window opens. This window is used to designate whether the snapshot of

the signal processing block is recalled when the external switch is closed

(ON) or open (OFF).

Figure 6.5 - Set Mode window

If there is only one action that is invoked by the external controller, then

choose ON or OFF based on which state should invoke the signal

processing block -- going active “ON”, or going active “OFF”. You do not

have to program both states. If there are two actions that are invoked by

the external controller, you can program both ON and OFF states. Drag

the block onto the same GPI but this time select the OFF state. Both

states will be programmed to the GPI.

Note: One scenario in which you might program both ON and OFF states

is the case of a “push-to-talk” button for a microphone. You could

program the system to mix in the microphone when the button is

pushed, and to remove the mic from the mix when the button is

released.

1 2 ... 123 124 125 126 127 128 129 130 131 132 133 ... 220 221

No comments

Bose ControlSpace User's Guide Page 128