Bose ControlSpace Installation Guide download pdf (Page 6)

Quick start

1. Run power and network (2-wire) cables from the ESP-88 to the CC-16 mounting location

and install a mounting box.

2. Set the DIP switches to define the unit address and termination (see silkscreen on back of

CC-16).

3. Connect the power and network wires to the CC-16’s terminal block and insert unit into

the mounting box.

4. At the ESP-88, connect the network wire to the RS-485 port and connect the power

cable to a power source.

5. Run the ControlSpace

Designer software to configure and test. The CC-16 must be

connected to an ESP and configured with the ControlSpace Designer software before it

can be used. Please refer to the Designer User’s Guide for complete details on configuring

and programming the CC-16 in a ControlSpace system.

CAUTION: The building code may require professional installation by a skilled technician or

licensed contractor.

Introduction

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

No comments

Bose ControlSpace Installation Guide Page 6