Bose ControlSpace Installation Guide download pdf (Page 14)

• Ensure that the power supply is wired correctly and plugged in

• Try disconnecting other CC-16s if sharing a supply

• Verify that the supply is DC and provides a minimum 100mA at 8V

• Press a button to see if backlight comes on (the backlight turns off

after a period of inactivity)

• Check to see if the device is connected to an ESP-88

• Check the polarity of the wiring to the ESP-88 (A->A, B->B)

• Check the DIP switch settings (2X should be ON )

• If this is the end of a long run, check that the termination DIP

switches are set to ON

• Check that the Select and/or Volume parameters have been pro-

grammed using the Designer software. Refer to the ControlSpace

Designer Software user’s guide for more information

• Check that the controls have been linked (in the Designer software)

to signal processing blocks in the ESP-88

• Ensure that the CC-16 address (set with DIP switches) matches the

address of the device you programmed in Designer

• Check that the system is not muted

• Check that other components (sources and amps) are not muted

and are wired correctly

• Verify that an ESP-88 has been added to your design

• Verify that the ESP-88 “finds” the CC-16. (Look for the CC-16 in the

Properties window and be sure it corresponds with the address

you set on the CC-16.)

Troubleshooting

No power

Screen is blank

No response when

Volume or Select

up/down buttons

are pressed

Power on, but no

sound

Cannot “find” the

device in Designer

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

No comments

Bose ControlSpace Installation Guide Page 14