Bose X User Manual download pdf (Page 8)

To install a new liner

Lift the old foam liner out of the earcup.

Place the nesv foam liner in the earcup cavity.

NOTE: The left and right foam liners are

different. With the correct liner in place, nesting

along the walls of tf)e cavity, its haff-moon

shaped opening should cover the micro

phone. and the small openirtg in the foam

should cover the small hole (see Rgure 6).

Careful ly align each liner so that

the small round opening in the foam

covers the small hole.

To clean the cushion

Using a baby wipe or a cloth moistened

with isopropyl alcohol, gentfy wipe «те side of

the cushion that touches the ear. Let

the cushion air dry. then dust with talcum

powder.

To replace the cushion

1. Place the nev/cushion inside the trim ring.

Align the cu^ion/trim ring, with its flat

edge forward. to the earcup.

NOTE: The small holes in backoff

cushion sixxjidnest on the posts on the

earcup. If both old cubions have been

rennoved. note that there are left and right

trim rings. The left ring vwll not fit on the

right earcup.

2. Snap the trim ring down firmly along its

circumfererrce. Make sure that the trim ring

is not grabbing the side of the cushion at

any spot. If it is. pull the skin of the cushion

free at that spot.

3. Reptoce the foam liner surd cushion on the

other earcup in the same manner.

Headset Orientation

Headset cable routing

The Headset cable can be routed to descend

from either the left or right earcup. The cable

should be re-routed if it crosses your Chester

interferes with your movements in flight,

To re-route the cable

1. Remove the headband cover by extend

ing the headband to maximum height.

Urvsnap each eixi of the headband cover

and peel apart the Velcro seam.

2. Unwind the Headset cable from the

earcup cable. Release the Headset cable

from the groove at the back of the pivot

block (see Figure?).

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments