Bose X User Manual download pdf (Page 11)

6.

Route the boom cable to the earcup on

which the boom is to be installed. If the

boom is to be installed on the right earcup.

do not route the cable sharply from the

molded block in the center of the head-

barxJ. Route the cable in a small loop to ttte

left of this block, then in back to the right

{see Rgure 12).

Route the cable to the left and then in ba<*

lothe right of the block.

a

9.

7. Place the connector to the Side of the

molded block closest to the earcup on

which the microphone will be installed.

Thread the mic cable through the groove

in the pivot block.

Wrap the boom and cable around the

earcup cable three times by passing the

boom between the yoke arm and earcup

cable, from back to front.

10. Snap the boom firmly into the clip so that

one of the rectangular faces on the

coupling is visible v;hen the boom snaps

into place (see Figure 13). Be sure that the

word “TALK" on the micrc^hone faces the

mouth

Figure 13

Make sure the rectangular face shows when

the boom snaps into place.

11. Replace the foam pad and wrap the

cover around the headband with the

opening to the rear. Sr^ap it at both er>ds

and seal the Velcro (see Figure 9 on

page 7).

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments