Bose X User Manual Page 10

  • Download
  • Add to my manuals
  • Print
  • Page
    / 16
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 9
Microphone boom relocation
To suit your personal preference, the Headset
boom can be moved from one earcup to the
other. This requires the use of a small screv;-
driver and can be accomplished as follov/s:
1. Remove the headband cover by extend
ing the headband to maximum height.
Unsnap each end of the headband cover
and peel apart the Velcro seam.
Z Remove the boom from the clip by pulling
the boom down just in front of the clip to
snap it out (see Figure 10).
3. Use a small scresvdriver to remove the
screw holding the clip. The screw is held
captive by an E-ring, v/hich must be in
place for the assembly to work correctly.
4. Using the same saew. fasten the clip
to the other earcup (see Rgure 11 ). Be
sure the E-ring is in place and seated. The
angled face of the clip should be posi
tioned to-ward the rear. Tighten the screw
until it bottoms. Do not continue to tighten.
Friction in turning this screw ensures that
the screw does not loosen over time.
5.
Unwnd the boom and cable from the
earcup cable. Rerrxjve the boom cable
from the groove at the rear of the pivot
block.
8
Figure 10
Pull the boom down in front of
the clip to snap ¡tout.
Figure 11
With the E-ring in place, screw the cl ip
to the other earcup.
Page view 9
1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments