Bose Wave PCinteractive Operations Instructions download pdf (Page 50)

50 April 12, 2001 PDF259774_00

Using the Wave/PC

™

Unit Controls

Waking to a preselected AM/FM station

Select ALARM or ALARM 2. Press and hold Alarm Set, and then press one of the six station

Presets buttons (you can change between AM and FM if needed). To clear the preset, press

and hold Alarm Set and press the button for that preset again.

Stopping the alarm

Press the On/Off button (or the stop ■ button on the remote). The indicators remain lit.

If you do not turn off the alarm, the tone alarm shuts off in 30 minutes, the radio alarm

shuts off in 60 minutes. The alarm automatically resets to repeat daily.

Pausing the alarm for 10 minutes

Press the Sleep/Snooze button (or the Snooze/Mute button on the remote).

When the Alarm Mode is set for both music and tone alarms, press the Sleep/Snooze

button to pause the tone for 10 minutes and turn on the music. Press again to silence the

music – the tone repeats in 10 minutes.

You can repeat the snooze cycle as many times as you want. If you do not press any button

while the tone is sounding, it continues for 30 minutes and then shuts off automatically.

Setting the volume of the music alarm

Press the Volume up or down button.

When the music alarm turns on, the alarm volume gradually increases to the last volume set-

ting used. You can set the volume level with the Wave/PC

™

unit on or off.

Setting the volume of the tone alarm

While the tone alarm is sounding, press the Volume up or down button.

When the tone alarm turns on, the tone alarm volume gradually increases to the last volume

setting used.

Using the alarm during a power loss

On the control panel only, press the On/Off button to silence the alarm.

The 9V backup battery operates only the tone alarm for approximately 48 hours following the

loss of AC power. To conserve power, only the tone alarm sounds even if the radio alarm is

also selected. Normal operation resumes when AC power is restored.

Note: The Wave/PC system does not respond to remote control commands during an AC

power outage. Be sure to replace the 9V battery after an extended power loss. For battery

replacement instructions, see “Setting up the Wave/PC™ remote control” on page 8.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 63 64

No comments

Bose Wave PCinteractive Operations Instructions Page 50