Bose CE-1 CONTROL EXPANDER UNIT Operations Instructions Page 78

  • Download
  • Add to my manuals
  • Print
  • Page
    / 84
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 77
78
GB
No sound is output from the receiver
and TV speaker while using the System
Audio Control function.
• Make sure the TV is compatible with the
System Audio Control function.
If the TV does not have System Audio
Control function, set the “AUDIO OUT”
settings in HDMI menu to
“TV+AMP” if you want to listen to the
sound from the TV speaker and
receiver.
“AMP” if you want to listen to the
sound from the receiver.
If you cannot listen to the sound of a
component connected to the receiver
Select the appropriate input when you
want to watch a program on a
component connected via HDMI
connection to the receiver.
Change the TV channel when you want
to watch a TV broadcast.
Select the component or input you want
to watch when you watch a program on
the component connected to the TV.
Refer to the operating instructions of the
TV on this operation.
The TV’s remote cannot be used to
control the connected component
when using the Control for HDMI
function.
• Change the input of the receiver to the
HDMI input connected to the component.
The FM reception is poor.
Use a 75-ohm coaxial cable (not supplied)
to connect the receiver to an outdoor FM
antenna (aerial) as shown below. If you
connect the receiver to an outdoor antenna
(aerial), ground it against lightning. To
prevent a gas explosion, do not connect the
ground wire to a gas pipe.
Radio stations cannot be tuned in.
Check that the antennas (aerials) are
connected securely. Adjust the antennas
(aerials) and connect an external antenna
(aerial), if necessary.
The signal strength of the stations is too
weak (when tuning in with automatic
tuning). Use direct tuning.
Make sure you set the tuning interval
correctly (when tuning in AM stations
with direct tuning).
No stations have been preset or the preset
stations have been cleared (when tuning
by scanning preset stations). Preset the
stations (page 59).
Press DISPLAY repeatedly so that the
frequency appears on the display.
Tuner
ANTENNA
AM
Receiver
To ground
Ground wire
(not supplied)
Outdoor FM antenna (aerial)
Page view 77
1 2 ... 73 74 75 76 77 78 79 80 81 82 83 84

Comments to this Manuals

No comments