Bose Acoustimass 20 Technical Information Page 12

  • Download
  • Add to my manuals
  • Print
  • Page
    / 23
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 11
12 October 29, 2001 AM25212_02_V.pdf
Connecting the Acoustimass
®
module to your receiver
CAUTION:
Do not connect the Acoustimass module directly to your television unless the
television provides surround decoding circuitry and amplified outputs for all channels.
Use the 20 foot (6 m) cable with five wire pairs to connect the Acoustimass module to your
surround sound receiver. Refer to Figure 8.
1. Connect all wires to the receiver in phase (+ to + and to ).
a. Connect each wire marked with a red collar (+) to the appropriate red (+) output.
b. Connect each plain wire () to the appropriate black () output.
2. Match the label on the red collar of each wire pair to the SPEAKER OUTPUT label on the
receiver:
a. LEFT wires go to the LEFT FRONT SPEAKER OUTPUT connections.
b. CENTER wires go to the CENTER SPEAKER OUTPUT connections.
c. RIGHT wires go to the RIGHT FRONT SPEAKER OUTPUT connections.
d. LEFT SURROUND wires go to the LEFT SURROUND (rear) SPEAKER OUTPUT
connections.
e. RIGHT SURROUND wires go to the RIGHT SURROUND (rear) SPEAKER OUTPUT
connections.
3. At the Acoustimass module, check to make sure all connectors are firmly inserted into the
proper INPUTS FROM RECEIVER OR AMPLIFIER jacks. Black connectors go into L and R
jacks. Gray connectors go into C, LS, and RS jacks.
Checking your connections
Check all connections from the receiver to the Acoustimass module and the module to the
cube speakers. Check to be sure all speakers are connected to the proper terminals accord-
ing to their position in your room. Refer to Figure 8.
At the receiver, make sure the wires are connected in phase (+ to + and to ). Incorrect
wiring can result in a total loss of Acoustimass module output.
Be sure to correct any wiring problems before you plug your receiver in and turn it on.
CAUTION:
Do not allow exposed wires to brush against each other; this could damage your
receiver.
Setting Up Your Acoustimass
®
6 Speaker System
Page view 11
1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 22 23

Comments to this Manuals

No comments