Bose T1 User Manual download pdf (Page 59)

CARE & MAINTENANCE

SvenskaItalianoFrançaisEspañolDeutschDanskEnglish Nederlands

Not hearing any effects. • Check that you pressed the correct CH Edit button.

• Make sure the FX Mute button is not pressed for the channel in question.

T1 not responding to

control knobs.

• Turn off the audio engine. Wait 30 seconds and turn unit on again.

Master volume control has

no effect.

• Verify that the Master output is configured for Post Master Volume operation in the Prefs menu under Master

Out.

With nothing plugged into

the T1 input connectors, a

slight hum or buzz is heard

from the L1 system.

• Plug the T1 and the L1

power stand into the same AC (mains) outlet.

• Using an AC outlet tester, test the AC outlet that the T1 and/or the L1 power stand is plugged into for reversed

or open (hot, neutral, and/or ground) contacts.

• If using an extension cord, make sure that the cord is also tested as above.

Too much (or not enough)

bass, mid-range, or high

frequencies.

• Make sure there is no unwanted zEQ or Para EQ equalization applied.

• Verify that you have selected an appropriate ToneMatch

engine preset for your microphone/instrument. If you

do not want to use a ToneMatch engine preset, make sure ToneMatch is set to Flat in the Utility category.

Poor-sounding playback of

a stereo recording using a

CD player, MP3 player, or

other such device.

• Connect the left channel of the device to T1 input channel 4 and the right channel to T1 input channel 5.

Channels 4/5 are designed for line-level inputs.

• Disable any extended bass or EQ features when using CD or MP3 players.

• If you are using recording software on a computer, check the software requirements. You may need to configure

the software settings for 48kHz/24-bit operation.

If using the T1 with an L1 model I system:

•Do not use a female

/8" stereo-to-male ¼" stereo adapter when connecting a portable device to an input

channel on the L1 model I power stand. The L1 model I input channels use a monaural (TS) connection. Use a

stereo-to-monaural adapter.

Problem What to do

1 2 ... 54 55 56 57 58 59 60 61 62

No comments

Bose T1 User Manual Page 59