Bose OC-1 AWCS-II Service Manual Page 11

  • Download
  • Add to my manuals
  • Print
  • Page
    / 22
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 10
10
E. Remove the lock nut and washer from the
harness (Figure 10A).
F. Thread the harness through the rear
panel (white connector first).
G. Turn the barrel connector so that its flat
side matches the flat side of the hole in the
controller. The connector should sit firmly
against the outside of the rear panel (Figure
10B).
H. Replace the lock nut and washer on the
harness inside the rear panel. Tighten firmly
with needle nose pliers (Figure 10C).
2. Connecting the OC-1 to the controller
NOTE: The controller's rear panel should
face you and the internal harness should be
inside.
A. Turn the OC-1 PCB so that its component
side faces you.
B. Connect the harness to J1 on the OC-1
PCB (Figure 11).
C. Plug the PCB into the connector
receptacles located on the controller's PCB.
See Figure 12 for proper orientation.
3. Installing the External Protection Circuit
Harness
A. Attach the external harness to the internal
harness connector (Figure 13) by turning
the notch on the harness to the right.
B. Hand tighten the lock nut on the external
harness.
Figure 10. Internal Harness Connection
Figure 11. System Controller Connection
Figure 12. OC-1 connected to controller PCB
10A
10C
10B
Flat side of barrel
Page view 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 21 22

Comments to this Manuals

No comments