Bose L1 Model II User Manual download pdf (Page 21)

YSTEM SETUP

English Deutsch FrançaisDansk Español Italiano SvenskaNederlandsDansk Italiano SvenskaDeutsch NederlandsEnglish FrançaisEspañol

Adding a second B1 bass module (optional)

The bass module output of the power stand can adequately drive one or two B1 bass

modules. When placed horizontally, the modules are stackable (Figure 9).

One or two additional B1 modules can be added with the use of a PackLite

power amplifier.

Refer to

“Adding a PackLite

power amplifier model A1 (optional)” on page 14.

CAUTION: Do not connect more than two B1 bass modules to the Bass Module Out

connector on the power stand. Driving more than two B1 bass modules from this output

improperly loads the amplifier in the power stand, resulting in less than full system performance.

1. Connect the first B1 to the Bass Module Out connector on the power stand.

2. Plug one end of the second B1 cable into the unused connector of the first B1. Plug the

other end of the cable into one of the connecetors of the second B1.

Figure 9

Installation of two B1 bass

modules

Second B1

bass module

cable

First B1 bass

module cable

Bass Module Out

VeniceOG.book Page 13 Tuesday, January 16, 2007 1:28 PM

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 31 32

No comments

Bose L1 Model II User Manual Page 21