Bose Acoustimass 16 User Manual download pdf (Page 12)

Setting Up

Checking the connections

Check all connections from the receiver to the Acoustimass

module and from the module to

the cube speaker arrays (Figure 5 and Figure 6). Make sure all cube speaker arrays are con-

nected to the proper terminals according to their position in your room. Check that all wires

are connected to your surround receiver in phase (+ to + and – to –). Incorrect wiring can

result in a total loss of module output. Correct wiring problems before you plug your receiver

in and turn it on.

Connecting the Acoustimass module to power

Note: Bose

recommends using a quality surge suppressor on all electronics equipment.

Voltage variations and spikes can damage electronic components in any system. A quality

suppressor can eliminate the vast majority of failures attributed to surges and may be pur-

chased at an electronics store.

After you have checked all system connections, plug the power cord of the powered Acousti-

mass module into an AC (mains) receptacle. Your Acoustimass speaker system will turn on

and off automatically as it receives a signal from your surround receiver.

Upgrading your Acoustimass 15 Series II speaker system

Your Acoustimass 15 Series II speaker system can be upgraded to provide you with 6.1 or

6 channel surround sound.

The 6.1 upgrade kit contains one black (PC 029661) or white (PC 029662) cube speaker array,

a 50-foot connecting cable, and complete connection instructions.

To purchase the 6.1 upgrade kit, contact your local authorized Bose retailer or call Bose

directly. See the list of Bose ofﬁces and phone numbers enclosed with your system. When

ordering, you will need to know the serial number of your Acoustimass module.

AM264924_00 _V.pdf • August 13, 2002

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18

No comments

Bose Acoustimass 16 User Manual Page 12